Get The Important Preparation Guide With 350-501 Dumps
Get Totally Free Updates on 350-501 Dumps PDF Questions
NEW QUESTION # 120
Refer to the exhibit:
This configuration is being applied on an IOS XR router.
Which statement about this configuration is true?
- A. It is used to enable gRPC
- B. It is used to create a streaming subscription with a 60-second interval
- C. It is used to set up configuration to poll network data
- D. It is used to create a streaming subscription with a 600-second interval
Answer: D
NEW QUESTION # 121
Refer to the exhibit.
Refer to the exhibit. A network engineer is configuring router RB to secure BGP advertisements against route hijacking activity. RB must validate all prefixes that it receives from origin AS 200 before installing them in the BGP route table. Which configuration meets the requirement?
- A. RB(config)# router bgp 100
RB(config-router)# address-family ipv4 unicast
PB(config-router-af)# bgp origin-as validation enable - B. RB(config-bgp)# router bgp 100
RB(config-bgp)# bgp origin-as validation time off - C. RB(config)# router bgp 100
RB(config-router)# address-family ipv4 unicast
RB(config-router-af)# bgp bestpath origin-as use validity - D. RB(config-bgp)# router bgp 100
RB(config-bgp)# bgp origin-as validation signal ibgp
RB(config-bgp)# bgp bestpath origin-as allow invalid
Answer: A
NEW QUESTION # 122
Refer to the exhibit:
P3 and PE4 are at the edge of the service provider core and serve as ABR routers Aggregation areas are on either side of the core.
Which statement about the architecture is true?
- A. If each area is running its own IGP. BGP must provide an end-to-end MPLS LSP
- B. To support seamless MPLS. TDP must be used as the label protocol
- C. If each area is running its own IGP. the ABR routers must redistribute the IGP routing table into BGP
- D. To support seamless MPLS, the BGP route reflector feature must be disabled
Answer: A
NEW QUESTION # 123
Refer to the exhibit.
An engineer began to configure LDP between R1 and R2, but R1 and R2 cannot yet establish an LDP TCP connection. Which additional task must be completed to finish the implementation?
- A. Configure the no mpls Idp password option 1 command on R2
- B. Configure the mpls Idp neighbor 10.0.12.1 password command on R1
- C. Configure the no mpls Idp password option 1 command on R1
- D. Configure the mpls Idp neighbor 172.16.0.1 password command on R1
Answer: D
NEW QUESTION # 124
An engineer is developing a configuration script to enable dial-out telemetry streams using gRPC on several new devices. TLS must be disabled on the devices.
Which configuration must the engineer apply on the network?
- A.
- B.
- C.
- D.
Answer: D
NEW QUESTION # 125
Refer to the exhibit.
A network administrator is implementing IGMP to enable multicast feed transmission to the receiver. Which configuration must the administrator deploy on GW1 to permit IGMP Joins only to the assigned (S, G) feed?
A)
B)
C)
D)
- A. Option B
- B. Option D
- C. Option C
- D. Option A
Answer: A
Explanation:
NEW QUESTION # 126
Refer to the exhibit:
A network engineer is implementing QoS services. Which two statements about the QoS-group keyword on Cisco IOS XR 3re true? (Choose two )
- A. QoS group marking occurs on the ingress
- B. The QoS group numbering corresponds to priority level
- C. QoS group can be used in fabric QoS policy as a match criteria
- D. It cannot be used with priority traffic class
- E. It marks packets for end to end QoS pokey enforcement across the network
Answer: C,D
NEW QUESTION # 127
Refer to the exhibit:
Which condition must be met by the OSPF peer of router R1 before the two devices can establish communication?
- A. The OSPF peer must use clear-text authentication
- B. The OSPF peer must be configured as an OSPF stub router
- C. The interface on the OSPF peer may have a different key ID, but it must use the same key value as the configured interface
- D. The interface on the OSPF peer must use the same key ID and key value as the configured interface
Answer: C
NEW QUESTION # 128
Refer to the exhibit:
If router RA is configured as shown, which IPv4 multicast address space does it use?
- A. 224.0. 0.0/8
- B. 239.0. 0.0/8
- C. 225.0. 0.0/8
- D. 232.0. 0.0/8
Answer: D
NEW QUESTION # 129
Which utility must be used to locate MPLS faults?
- A. MPLS LSP ping
- B. MPLStraceroute
- C. EEM
- D. QoS
Answer: B
NEW QUESTION # 130
After a possible security breach, the network administrator of an ISP must verify the times that several different users logged into the network. Which command must the administrator enter to display the login time of each user that activated a session?
- A. show netconf-yang datastores
- B. show netconf-yang sessions
- C. show platform software yang-management process
- D. show netconf-yang sessions detail
Answer: D
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/prog/configuration/167/b_167_programmability_cg/configuri
NEW QUESTION # 131
An engineer is trying to implement BGP in a multihomed architecture. What must the engineer configure to influence inbound path selection?
- A. An access list to Klentify traffic and enable it on both of the provider-facing Interfaces.
- B. An offset list to set the metric for routes received from neighboring autonomous systems.
- C. A route map with AS_PATH attribute to control the inbound traffic.
- D. A route map with WEIGHT attribute to control the inbound traffic.
Answer: C
NEW QUESTION # 132
Drag and Drop Question
Drag and drop the LDP features from the left onto the correct usages on the right.
Answer:
Explanation:
NEW QUESTION # 133
What causes multicast traffic to permanently stay on the shared tree and not switch to the source tree?
- A. The SPT threshold is set to infinity
- B. SSM range is being used
- C. The RP announcements are being filtered
- D. The RP IP address is configured incorrectly
Answer: C
Explanation:
Section: Services
NEW QUESTION # 134
Refer to the exhibit:
BGPsec is implemented on R1. R2. R3. and R4 BGP peering is established between neighboring autonomous systems Which statement about implementation is true?
- A. BGP updates from the eBGP peers are appended with an additional AS path value that is statically set by the domain administrator
- B. BGP updates from the eBGP peers are appended with a BGPsec attribute sequence that includes a public key hash and digital signature
- C. BGP updates from the iBGP peers are appended with a community of local-as
- D. BGP updates from the all BGP peers are appended with a community of no export
Answer: B
NEW QUESTION # 135
Which configuration enables BGP FlowSpec client function and installation of policies on all local interfaces?
- A. flowspec
address-family ipv4
local-install interface-all - B. flowspec
address-family ipv4
local-install all-interface - C. flowspec
address-family ipv4
install interface-all local - D. flowspec
address-family ipv4
install interface-all
Answer: A
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/iproute_bgp/configuration/xe-16-6/irg-xe-16-6- book/C3PL-BGP-Flowspec-Client.html
NEW QUESTION # 136
Drag and drop the LDP features from the left onto their usages on the right.
Answer:
Explanation:
NEW QUESTION # 137
A service provider requires continuous real-time network monitoring to provide reliable SLAs to its customers. To satisfy this requirement, a network administrator is implementing gRPC dial out on an ASR with TLS. Receiver 192.168.10.2 will be assigned one of the subscriptions, and it will manage the ASR. Which configuration must the engineer apply to the router as part of the configuration process?
- A. snmp-server community public
snmp-server enable traps
snmp-server host 192.168.10.2 version 2c public. - B. telemetry model-driven
destination-group ciscotest
address family ipv4 192.168.10.2 port 10
encoding self-describing-gpb
protocol grpc tis-hostname ciscotest.com - C. telemetry model-driven
destination-group DGroup1
address family ipv4 192.168.10.2 1 port 10
encoding self-describing-gpb - D. snmp-server community public
snmp-server enable traps
snmp-server enable traps snmp authentication
snmp-server manager
snmp-server manager session-timeout 1000
Answer: B
NEW QUESTION # 138
......
Prepare With Top Rated High-quality 350-501 Dumps For Success in Exam: https://www.lead2passexam.com/Cisco/valid-350-501-exam-dumps.html
350-501 Free Certification Exam Easy to Download PDF Format 2023: https://drive.google.com/open?id=1hOlxS3ngDTxDoKuH-_hD3hmnUrHhEZ6S